Curated Routine

3 AWESOME BALL STRIKING DRILLS

Golf
Training ~1 minStart follow-along — free, no signup
Created from “3 AWESOME BALL STRIKING DRILLS” by ChrisRyanGolfWatch original

3 AWESOME BALL STRIKING DRILLS is a curated workout routine with 3 ordered actions and 3 short form clips. Start with Impact Spray Centered Contact Drill / Strike Feedback and Environmental & Uneven Lie Variability Drill / Slopes & Rough. Review the available targets, sets, coaching cues and rest for each action. Estimated training time is about 1 min; rest is listed per action.

Training ~1 minOriginal video 9:043 actionsSingle training session
Start this session

Follow in order

Action Sequence

Browse all actions
0:00 / 1:36
1

Impact Spray Centered Contact Drill / Strike Feedback

Sets: 1Reps: 6 repsRest: 0 secClip: 1 min 36 sec

Using impact spray, foot spray, or dry shampoo on the clubface to get immediate visual feedback on strike location, helping golfers hone in on centered contact.

Before you start

  • Select a club (e.g., a 7-iron).
  • Apply strike spray, foot spray, or dry shampoo to the face of the club to leave a clear mark upon impact.

Movement sequence

  1. Spray the clubface thoroughly.
  2. Hit golf shots without intentionally trying to change your swing mechanics initially.
  3. Inspect the clubface after each shot to see where the ball made contact (e.g., heel, toe, or center).

Key points

  • Check the spray mark on the clubface after each shot.
  • Observe whether the strike is favoring the toe, heel, or center.

Common mistakes

Trying to make drastic swing changes immediately rather than letting visual feedback guide natural micro-adjustments. Ignoring the strike pattern feedback across multiple shots.

Practice notes

Having immediate feedback each time you hit a golf shot is unbelievably good for focusing in on centered contact. Work through the bag to hone in on the center point.

0:00 / 2:49
2

Environmental & Uneven Lie Variability Drill / Slopes & Rough

Sets: 1Reps: 10 repsRest: 0 secClip: 2 min 49 sec

Introducing environmental variability and uneven lies (using foam squares, rough mats, or depressions) to replicate golf course challenges and test your ability to find the center of the club.

Before you start

  • Set up your hitting area with tools to create variability, such as foam squares under your feet to simulate uneven lies.
  • Spray the clubface with strike spray for feedback.

Movement sequence

  1. Stand on foam squares to create an uneven stance (replicating ball below/above feet or slopes).
  2. Alternatively, place the ball in the rough part of the mat where it sits higher, or in a driver tee hole to simulate a depression.
  3. Hit shots while adapting to the altered environment and strive to still find the center of the clubface.

Key points

  • Notice how the ball sits higher in the rough (often resulting in contact near the top few grooves if adjustments aren't made).
  • Monitor clubface strike marks while out of your comfort zone.

Common mistakes

Failing to adjust setup or expectations when the ball sits higher in the rough. Allowing uneven lies to disrupt your rhythm without focusing on centered contact.

Practice notes

Golf courses put you out of your comfort zone with uneven lies; this drill builds the skill and adaptability required on the course. Combines technical setup with skill, talent, and adaptability.

0:00 / 2:13
3

Own the Strike Face-Quadrant Calibration Drill / Intentional Off-Center Shots

Sets: 1Reps: 10 repsRest: 0 secClip: 2 min 13 sec

Splitting the clubface into four quadrants using a tee peg and intentionally trying to hit shots from specific areas (low-toe, high-toe, low-heel, high-heel) to develop superior control over club delivery.

Before you start

  • Take a driver (or another club) and spray the face.
  • Use a tee peg to draw two lines (vertical and horizontal) splitting the clubface into four quadrants: low-toe, high-toe, low-heel, and high-heel.

Movement sequence

  1. Maintain a consistent setup stance without changing how you address the ball.
  2. Intentionally attempt to strike the golf ball from each of the four designated face quadrants.
  3. Observe where the spray mark lands relative to your target quadrant and evaluate your ability to control strike location.

Key points

  • Verify whether the impact mark corresponds to the intended quadrant (e.g., high-toe vs low-heel).
  • Assess your awareness of the clubhead's position throughout the entire golf swing.

Common mistakes

Changing your setup address position when trying to hit different quadrants. Expecting immediate perfection when attempting intentional off-center strikes, as developing this skill takes practice.

Practice notes

The best golfers in the world have the skill to control where the club is delivered and can adjust if they trend toward the toe or heel. Gaining control over strike location allows you to correct mis-hits on the course through natural skill rather than major mechanical overhauls.

Video demonstrations are referenced from public platforms for instructional context. TrainFlow is independent and not affiliated with or endorsed by the original content creators.